A place for me to display some of the varied projects that come out of my shop, as well as to "talk" about some of my experiences working with wood.

Saturday 14 November 2015

KUBISK Dresser complete

Bedroom set complete!


The completed dresser! Yea!
Last week was a busy one in the shop as I finished and delivered the last major piece for the bedroom set I am building for my youngest son.

The set includes the cantilevered night stands, the king size bed, tall chest of drawers and this longer dresser. This piece is substantial at 67" long and will provide plenty of storage with 30" wide drawers.





The skeleton of this beast.





The build started out the same as the other case pieces in this set with end frames domino'd together and an inset plywood panel, bottom rails and a web frame for the top.







Next the top is fitted, wood choice was key here and nice piece with gum and good figure was used for the front piece. The request was to use the interesting figure of the cherry to paint a picture. That's why you will see some sapwood in places. Some details were important to me and not likely noticed by the users, such as using the most interesting part of the plywood in the end panel that had some nice curl. Also wrapping the grain around the front and top of the side panels took some time to get right.


Fitting the top, this is challenging as the top is captured between the two frames and has to be exact.

The internal structure of the piece is provided by web frames, this simple form built with dominos (of course) ties the two ends together and provides the support to carry the weight of the drawers. The centre vertical rail carries the load down to a centre beam where a hidden fifth leg delivers the load to the floor. Since this part of the carcase carries over half the load, i wanted to ensure this did not sag in the next hundred years.

The outside surfaces with a coat of danish oil to avoid soiling from handling. The full-extension
black slides have also been installed.

Of course all the drawers were dovetailed.
Not by hand though!!
 The drawer fronts are all single pieces of cherry as in the chest, the horizontal grain alignment is another one of those details I insisted on. The drawer sides are 1/2" ash which is my favourite wood for this purpose. Mostly because the grain of the ash is so interesting and adds something I like. I saw this approach at the Thomas Moser factory and it was a nice detail I chose to adopt as a bit of a signature - thanks Tom!


The drawers are dry-fitted for spacing and rough alignment

Before the back goes on to tie all the structure together.
Making sure all the drawers fit and align properly, this is way easier with the back off.

Drawer detail, shows lip created to capture and hide the slides, inset
half dovetails and that lovely ash figure.

Close up detail of front.
And what's a dresser without a proper mirror. I threw this together with left over material
Nice sapwood eh? (In case you did not notice, this is a mirror frame, not an actual mirror!!)

4 comments:

  1. Nice work, I don't blame you on the dovetails! All the best, David.

    ReplyDelete
  2. I like the simplicity of the design, and function.

    ReplyDelete